Siemens TC12 사용자 설명서
TC12 Installation, Commissioning & Maintenance Handbook
3.3.3.53 Display PLD Variant (GPV, KPV)
GPV<enter>
C
C
3.3.3
the instation to
be displayed in binary format.
address, MT bit etc. The first byte of reply data is accessed using GRD 1.
3.3.3
AC (sensor number: 1-23) (current/voltage selector: 0-1) <enter>
Monitor sensors.
Note: The lamp monitor facility must be enabled for ADC readings to be
3.3.3
V, with the associated
3.3.3
e and colour.
3.3.3.58 Display lamp supply voltage (KEV)
in volts. If no second lamp supply is
3.3.3
r: 0 - 6)<enter>
inary byte containing a set of flags (i.e. bits) indicating
possible aspect pattern of each possible current sensor.
hose flags for valid aspect patterns of used sensors are generated,
ers are set to zero.
omment:
Displays PLD Reference Number and Issue State.
.54 Display Reply Data (GRD)
GRD (reply byte number: 0 - 14) <enter>
Comment: Enables the reply data currently being transmitted to
Note: GRD 0 displays the first byte of the reply message that is the OTU
The display is only valid for the configured number of reply bytes.
.55 Display Lamp Monitor ADC readings (KAC)
K
Comment: Displays the ADC current or voltage readings for configured Lamp
available.
.56 Display learnt load (KEL)
KEL (sensor number: 1 - 23)(aspect pattern number, 0-6):<enter>[PB392 issue 6
or later]
Comment: Displays the learnt loan in Watts at 240
phase and colour. If the load is not learnt, the display will indicate
zero.
zero.
.57 Display actual current (KES)
KES (sensor number: 1-23)<enter>
Comment:
Displays the last current reading in milliamps on the Red or the
associated phas
KEV (Lamp Supply: 0-1)<enter>
Comment:
Displays the lamp supply
defined KEV will display ‘KEV 1:N/A’.
.59 Display LMU Aspect Learn Status (KAS)
AS (sensor number: 1-23) (aspect pattern numbe
K
Comment:
Displays a b
the status of LMU monitoring. There is one set of flags for each
Note: Only t
all oth
666/HE/43100/000
Page 110
Issue 9