Poulan DRT900 사용자 설명서

SERVICE AND ADJUSTMENTS

CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into

contact with plug.

TILLER

TO ADJUST HANDLE HEIGHT (See Fig. 23)

Select handle height best suited for your tilling conditions.

Handle height will be different when tiller digs into soil.
• First loosen handle lock lever.
•

Handle can be positioned at different settings between

“HIGH” and “LOW” positions.

• Retighten handle lock lever securely after adjusting.

Fig. 23

Fig. 24

HANDLE

(LOW POSITION)

HANDLE LOCK

LEVER

HANDLE

(HIGH POSITION)

Fig. 25

TO REMOVE BELT GUARD (See Fig. 25)

NOTE: For ease of removal, remove hairpin clip and

clevis pin from left wheel. Pull wheel out from tiller about

1 inch.
• Remove two (2) screws from side of belt guard.
•

Remove hex nut and washer from bottom of belt guard

(located behind wheel).

• Pull belt guard out and away from unit.
• Replace belt guard by reversing above procedure.

TIRE CARE

CAUTION: When mounting tires, un-

less beads are seated, over in fla tion can

cause an explosion.

• Maintain 20 pounds of tire pressure. If tire pressures

are not equal, tiller will pull to one side.

• Keep tires free of gasoline or oil which can damage

rubber.

TO REMOVE WHEEL (See Fig. 24)

• Place blocks under trans mis sion to keep tiller from

tipping.

•  Remove hairpin clip and clevis pin from wheel.
•  Remove wheel and tire.
•  Repair tire and reassemble.

tire_3

CLEVIS PIN

HAIRPIN CLIP

SCREW

AND

WASHER

HEX NUT

AND WASH-

(LOCATED

BEHIND

TIRE)

SCREW

AND WASHER

BELT GUARD

HAIRPIN CLIP

AND CLEVIS PIN