Oregon RMR616HGA 사용자 설명서
EN
6
CHANGE SETTINGS
1.
Press and hold MODE for 2 seconds to enter setting
mode.
mode.
2.
Press UP or DOWN to change settings.
3.
Press MODE to confirm.
GETTING STARTED
BATTERIES
Batteries are not supplied with this product. You will need
to purchase 2 x UM-3 (AA) 1.5V alkaline batteries for
the main unit, and 2 x UM-4 (AAA) 1.5V alkaline batteries
for the remote sensor.
to purchase 2 x UM-3 (AA) 1.5V alkaline batteries for
the main unit, and 2 x UM-4 (AAA) 1.5V alkaline batteries
for the remote sensor.
Insert batteries before first use, matching the polarity as
shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
shown in the battery compartment. For best results,
install batteries in the remote sensor before the main
unit. Press RESET after each battery change.
Do not use rechargeable batteries.
shows when batteries are low.
NOTE
UNIT
LOCATION
Main
Temperature Area when
the INDOOR
temperature is shown.
the INDOOR
temperature is shown.
Remote
Temperature Area when
the OUTDOOR
temperature is shown.
the OUTDOOR
temperature is shown.
REMOTE SENSOR (THGR122NX)
This product is shipped with a THGR122NX Thermo/
Hygro Sensor that collects Temperature and Humidity
data. Data can be collected from up to 3 sensors.
Additional sensors sold separately.
Hygro Sensor that collects Temperature and Humidity
data. Data can be collected from up to 3 sensors.
Additional sensors sold separately.
SETUP SENSOR
Open the remote sensor battery compartment with a
small Phillips screwdriver.
small Phillips screwdriver.
RMR616HGA lab test R2
1/17/04, 5:03 PM
6