Oregon RMR616HGA 사용자 설명서

EN

7

3.

Place the sensor near the main unit. Press RESET
on the sensor to initiate signal sending between the
sensor and the main unit. The reception icon on
the main unit will blink for approximately 3 minutes
while it is searching for the sensor. (Refer to the
Search for Sensor section for more information.)

4.

Close the remote sensor battery compartment.

5.

Secure the sensor in the desired location using the
wall mount or table stand.

For best results:

• Insert the batteries and select the channel

and temperature unit before you mount the
sensor.

• Place the sensor out of direct sunlight and

moisture.

• Do not place the sensor more than 30 meters

(98 feet) from the main (indoor) unit.

• Position the sensor so that it faces the main

(indoor) unit, minimizing obstructions such as
doors, walls, and furniture.

• Place the sensor in a location with a clear

view to the sky, away from metallic or
electronic objects.

• Position the sensor close to the main unit

during cold winter months as below-freezing
temperatures may affect battery performance
and signal transmission.

You may need to experiment with various locations to
get the best results.

To maximise Atomic Clock signal reception, the

main unit table stand should be fully opened until it locks
into place.

Data is sent from the sensor(s) every 40 seconds.
The reception icon shown in the Temperature and
Humidity Areas show the status.

SWITCH

OPTION

Channel

Channel 1 - 3. If you are using
more than one sensor, select a
different channel for each sensor.

1.

Insert the batteries, matching the polarity as shown
in the battery compartment.

2.

Set the channel. The switch is located in the battery
compartment.

RMR616HGA lab test R2

1/17/04, 5:03 PM

7