Multiquip MVC-64HW 사용자 설명서

2. The V-belt tension is proper if the V-belt bends 10 to 15 mm

(Figure 10) when depressed with finger at midway between
the clutch and vibration pulley shafts.

CLUTCH

PULLEY

VIBRATOR

PULLEY

1. To check  the V-belt tension, remove the  bolts that secure the

belt cover to the frame as shown in Figure 8.

3. A loose V-belt will decrease the power transmission output,

causing reduced compaction and premature wear of the
belt.

4. If the V-belt becomes worn or loose, replace it .

1. Place the MVC-64H/HW plate compactor horizontally on a

flat surface. Make sure the compactor is level when checking
the oil in the vibrator assembly.

2. Check  vibrator oil level by removing  the plug  (vibrator  oil gauge)

as shown in Figure 10.   The oil level should be up to the oil plug.
If oil is required, replace using only SAE 10W-30 motor oil.

NEVER attempt to check the V-belt with the engine running.
Severe injury can occur if your hand (Figure 7) gets caught
between the V-belt and the clutch. Always use safety gloves.