Sharp AR-M205 사용자 설명서

24

Memory allocated to 
printer mode

1: 30%
2: 40%
3: 50%
4: 60%
5: 70%

• Use this to change the proportion of machine 

memory used for printer mode.

25

Key auto repeat

0: OFF
1: ON

• Use this setting to select whether or not holding 

down a key causes repeated input of the key. 
For keys that normally cause a set value to 
increase when held down (for example, holding 
down the [ZOOM] key (

)), this program 

can be used to have the set value not change 
when the key is held down.

26

Key press time

(current response speed)

2: 0.5 sec.
3: 1.0 sec.
4: 1.5 sec.
5: 2.0 sec.

• Use this setting to select how long a key must 

be pressed for the input to be accepted. By 
selecting a longer time, you can prevent 
settings from being changed by the accidental 
pressing of a key. 

27

Audible signals volume

1: Low 

(current volume)

2: High
3: OFF

• This sets the volume of beep signals. (p.47) 

28

Base setting beep 
signal

0: OFF
1: ON

• Use this to sound a beep when a base setting is 

selected. (p.47)

29

Number of copies limit

1: 99 copies
2: 999 copies

• Use this setting to select 99 or 999 for the 

maximum number of copies.

30

Use close paper size

0: OFF
1: ON

• When this function is enabled, printing in printer 

mode will automatically continue using a 
different size of paper if the specified size of 
paper runs out in all trays. This feature does not 
function in copy mode.

31

Default tray setting

1: Upper paper tray*

4

2: Lower paper tray*

4

3: 250-sheet paper feed 

unit/
Upper paper tray of 2 
x 250-sheet paper*

4

 

feed unit

4: Lower paper tray of 2 

x 250-sheet paper 
feed unit*

4

5: Bypass tray*

4

• Use this program to select a default tray. This 

tray is automatically selected each time the 
power is turned on or each time the machine 
reverts to the initial settings.

32

Default exposure mode

1: AUTO
2: TEXT
3: PHOTO

• Use this program to set "AUTO", "TEXT", or 

"PHOTO" as the default exposure mode.

33

USB 2.0 mode 
switching

*5

1: Full-Speed
2: Hi-Speed

This sets the USB 2.0 data transfer speed. To 
obtain the fastest speed when using the USB 2.0 
port, first verify that your computer meets the 
system requirements (operating system and 
driver), and then use this program to change the 
USB 2.0 mode to "Hi-Speed". Note that the setting 
should not be changed while running a TWAIN 
driver. (For the system requirements, see "System 
requirements for USB 2.0 (Hi-Speed mode)" 
(p.38).)

(factory default setting 

appears in bold)

*

4

AR-M160 is as follow:
1: Upper tray (factory default), 2: 250-sheet paper feed unit/Upper paper tray of 2 x 250-sheet paper feed unit, 
3: Lower paper tray of 2 x 250-sheet paper feed unit, 4: Bypass tray

*

5

The scanning speed increases when the USB 2.0 mode is set to "Hi-Speed", however, the printing speed does not increase 
considerably.