Cisco Systems 1550 사용자 설명서
2-26
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01
Chapter 2 Installing the Access Point
Mounting the Access Point
Figure 2-16
Access Point 1552I Hanging in Mounting Bracket
Step 3
Screw a M8 x16 bolt (with flat and lock washers) into the second bolt hole on each side of the access
point (see
point (see
).
Step 4
Depending on what you purchased, ensure that the front of the 1552E/EU access point is vertical, or that
the 1552I access point is horizontal, and tighten the four bolts to 13 to 15 ft lbs
(17.6 to 20.3 Nm).
the 1552I access point is horizontal, and tighten the four bolts to 13 to 15 ft lbs
(17.6 to 20.3 Nm).
Step 5
. For the 1552I model continue
with
.
Installing 1552C or 1552CU in the Mounting Bracket
There are three different options for mounting the 1552C or 1552CU access point:
•
•
•
Cable Strand Mounting the 1552C or 1552CU Access Point
When mounting the access point on a cable strand, you must use the optional strand mount kit. The kit
contains several parts that you should assemble before mounting on a cable strand. To install the access
point to a cable strand, you need to perform these operations:
contains several parts that you should assemble before mounting on a cable strand. To install the access
point to a cable strand, you need to perform these operations:
•
Assemble cable brackets; attach cable clamps to the clamp bracket.
•
Attach the strand brackets to the access point.
•
Attach the clamp bracket to the fiber or cable strand.
•
Attach a ground wire.
•
Connect cables and power to the access point.
Note
The access point must be installed on a cable strand by a professional cable installer.
345826