Texas Instruments TMS320DM646x 사용자 설명서
www.ti.com
4.5
MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
MDIO Registers
The MDIO link status change interrupt (unmasked) register (LINKINTRAW) is shown in
and
described in
Figure 31. MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
31
16
Reserved
R-0
15
2
1
0
Reserved
LINKINTRAW
R-0
R/W1C-0
LEGEND: R = Read only; R/W = Read/Write; W1C = Write 1 to clear, write of 0 has no effect; -n = value after reset
Table 29. MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
Field Descriptions
Bit
Field
Value
Description
31-2
Reserved
0
Reserved
1-0
LINKINTRAW
0-3h
MDIO Link change event, raw value. When asserted, a bit indicates that there was an MDIO link
change event (that is, change in the LINK register) corresponding to the PHY address in the
USERPHYSEL register. LINKINTRAW[0] and LINKINTRAW[1] correspond to USERPHYSEL0 and
USERPHYSEL1, respectively. Writing a 1 will clear the event and writing a 0 has no effect.
change event (that is, change in the LINK register) corresponding to the PHY address in the
USERPHYSEL register. LINKINTRAW[0] and LINKINTRAW[1] correspond to USERPHYSEL0 and
USERPHYSEL1, respectively. Writing a 1 will clear the event and writing a 0 has no effect.
0
No MDIO link change event.
1
An MDIO link change event (change in the LINK register) corresponding to the PHY address in
MDIO user PHY select register n (USERPHYSELn).
MDIO user PHY select register n (USERPHYSELn).
74
Ethernet Media Access Controller (EMAC)/Management Data Input/Output (MDIO)
SPRUEQ6 – December 2007