IBM 61Y 사용자 설명서
40
Hardware Maintenance Manual: xSeries 250
NDIS 4.0 (Windows NT) driver messages
This section contains the error messages for the NDIS 4.0 drivers. The explanation
and recommended action are included with each message.
and recommended action are included with each message.
PCNTNW-NW-
091
The hardware configuration conflicts.
Explanation:
You tried to load a new frame type for the existing
controller. The hardware assumptions made in doing so are incorrect.
This error can also occur if you try to specify a mode (such as,
redundancy) that conflicts with another specified mode.
Action:
This error can also occur if you try to specify a mode (such as,
redundancy) that conflicts with another specified mode.
Action:
Make sure that your hardware configuration matches the
software settings.
PCNTNW-NW-
126
The group bit in the node address override was cleared.
Explanation:
The IEEE address has a group bit that indicates that an
address belongs to a group of stations. This bit is used only as a
destination address; it cannot be used as a source address. You tried to
enter a source address with this bit set. The driver cleared the group bit
of the source address.
Action:
destination address; it cannot be used as a source address. You tried to
enter a source address with this bit set. The driver cleared the group bit
of the source address.
Action:
None necessary, message is for information only.
PCNTNW-NW-
127
The local bit in the node address override was set.
Explanation:
The local bit in the IEEE address format indicates that the
addresses are being managed locally. If you use the node address
override capabilities of this driver to enter a new address, the local bit
must be set. You entered an address without the local bit set. The driver
has set the local bit.
Action:
override capabilities of this driver to enter a new address, the local bit
must be set. You entered an address without the local bit set. The driver
has set the local bit.
Action:
None necessary, message is for information only.
PCNTNW-NW-
164
The device was not found.
Explanation:
The driver cannot find an Ethernet controller in the server.
Action:
Verify that the Ethernet controller is enabled. If the Ethernet
controller is enabled, go to “Starting the diagnostic programs” on page
26 to run the diagnostic programs.
26 to run the diagnostic programs.
PCNTNW-NW-
165
The device was not found at IOADDRESS.
Explanation:
The Ethernet controller cannot be found at the I/O address
specified.
Action:
Action:
The Ethernet controller does not require a parameter for the I/O
address. Remove the I/O address parameter.
PCNTNW-NW-
167
PCI scan specified, device not found.
Explanation:
The driver cannot locate the Ethernet controller on the PCI
bus.
Action:
Action:
Verify that the Ethernet controller is enabled. If the problem
persists, go to “Starting the diagnostic programs” on page 26 to run the
diagnostic programs.
diagnostic programs.
PCNTNW-NW-
180
The DMA parameter is not necessary for PCI device.
Explanation:
The Ethernet controller does not require a DMA setting.
Action:
None necessary, message is for information only.
Table 3. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet
controller.
controller.