Emerson ATCA-9305 사용자 설명서
Cavium Processor Complex:
Cavium Monitor
3-7
Figure 3-4:
Power-up/Reset CN5860 Boot Sequence Flowchart
Diagnostic Tests During Power-up and Reset
The Cavium monitor diagnostic tests can be executed during power-up or invoked from the
monitor’s command prompt. This is accomplished by changing the state of the monitor
configuration parameters that define power-up and reset diagnostics mode. If the poweron-
diags parameter is set to “on”, the monitor invokes the diagnostic tests after a reset of the
hardware. Results are displayed to the console including whether the test passed or failed.
monitor’s command prompt. This is accomplished by changing the state of the monitor
configuration parameters that define power-up and reset diagnostics mode. If the poweron-
diags parameter is set to “on”, the monitor invokes the diagnostic tests after a reset of the
hardware. Results are displayed to the console including whether the test passed or failed.
POST Diagnostic Results
The ATCA-9305 Power-On Self-Test (POST) diagnostic results are stored as a 32-bit value in
memory accessible by the management console at location 0x80080A6C. Each bit indicates
the result of a specific test, so this field can store the results of up to 32 diagnostic tests.
memory accessible by the management console at location 0x80080A6C. Each bit indicates
the result of a specific test, so this field can store the results of up to 32 diagnostic tests.
assigns the bits to specific tests.
Power-up or Reset
Cavium Hardware
Wait for PCI load of U-boot
U-Boot Monitor
Default Board Initialization
U-Boot Monitor
Execute POST
U-Boot Monitor
Start Autoboot Sequence
(Boot Operating System)
Operating System Boot
Boot OS image
according to
configuration parameters