Ampro Corporation 420 사용자 설명서

CoreModule 420

QuickStart Guide

7

11) Connect the OS boot devices

•  There are four options for connecting an (OS) boot device to the

CoreModule 420:

          Skip the devices that are not applicable to your situation.

a) Connect a floppy disk drive to the floppy/parallel cable

connected to J4 on the CoreModule 420.

b) Connect an IDE hard disk drive to one of the free connectors on

the IDE cable.

Use one of the free IDE pin adapter PCBs to connect the IDE hard
disk drive.

The IDE cable has two connectors with 2mm-to-0.1” adapters on
each one for connection to an IDE hard disk drive and CD-ROM.

Ampro does not recommend using a hard drive with a
preinstalled OS from another model PC, to boot the
CoreModule 420.  This has proven to cause problems or
provide unreliable operation.  Use a bootable device
(floppy, CD-ROM, or CF) to load the OS onto the hard
drive while attached to the CoreModule 420.  Additional
drivers can be loaded while still connected to the
CoreModule 420.  Refer to Step 21.

c) Connect a CD-ROM drive to the available connector on IDE

cable from J6 on the CoreModule.

Use the second or free IDE pin adapter PCB & 2mm connector
on the IDE cable to connect the CD-ROM drive.

d) Install a CompactFlash card with a bootable OS into the

CompactFlash socket (J12).

Instructions and limitations for installing the CompactFlash card into
the socket (J12) on the CoreModue 420 are provided in Chapter 2,
Installing CoreModule 420 Options later in this manual.

12)  Connect the device cables
       to the CoreModule cables

This includes the keyboard, mouse, CRT monitor, power supply,
and any remaining devices you want connected during the boot
process.

•

  

Connect the keyboard to the larger (DIN) connector on the

Utility cable.  If required, a PS/2-to-AT adapter is provided in
QuickStart Kit.

•  Connect the mouse to the PS/2 connector on the Utility cable.

• 

 

Connect the CRT monitor cable to the Video connector from J11

on the CoreModule.