Motorola MVME5100 사용자 설명서
2-1
2
2
Hawk PCI Host Bridge & Multi-
Processor Interrupt Controller
Introduction
Overview
This chapter describes the architecture and usage of the PowerPC to PCI
Host Bridge (PHB) and the Multi-Processor Interrupt Controller (MPIC)
portion of the Hawk ASIC. The Hawk is intended to provide PowerPC 60x
(PPC60x bus) compliant devices access to devices residing on the PCI
Local Bus. In the remainder of this chapter, the PPC60x bus is referred to
as the PPC bus and the PCI Local Bus as PCI. PCI is a high performance
32-bit or 64-bit burst mode, synchronous bus capable of transfer rates of
132MB/sec in 32-bit mode or 264MB/sec in 64-bit mode using a 33 MHz
clock.
Host Bridge (PHB) and the Multi-Processor Interrupt Controller (MPIC)
portion of the Hawk ASIC. The Hawk is intended to provide PowerPC 60x
(PPC60x bus) compliant devices access to devices residing on the PCI
Local Bus. In the remainder of this chapter, the PPC60x bus is referred to
as the PPC bus and the PCI Local Bus as PCI. PCI is a high performance
32-bit or 64-bit burst mode, synchronous bus capable of transfer rates of
132MB/sec in 32-bit mode or 264MB/sec in 64-bit mode using a 33 MHz
clock.
Features
❏
PPC Bus Interface
– Direct interface to MPC750, MPC755, or MPC7410 processor.
– 64-bit data bus, 32-bit address bus.
– Four independent software programmable slave map decoders.
– Multi-level write post FIFO for writes to PCI.
– Support for PPC bus clock speeds up to 100 MHz.
– Selectable big or little endian operation.
– 3.3 V signal levels
❏
PCI Interface
– Fully PCI Rev. 2.1 compliant.
– 32-bit addressing, 32 or 64-bit data bus.
– Support for accesses to all three PCI address spaces.
– Multiple-level write posting buffers for writes to the PPC bus.