Cisco Systems NPE-225 사용자 설명서

Use the show interface stats command for information about the interface.

Router#

 

GigabitEthernet0/1

          Switching path    Pkts In   Chars In   Pkts Out  Chars Out

               Processor      33090    6424353      86353    8645650

             Route cache          2        116          0          0

  Multi-Processor Fwding       1004     158632       5004     790632

                   Total      34096    6583101      91357    9436282

Use the show ip interface command to get information about the specific interface port.

Router# show ip interface g0/3 

GigabitEthernet0/3 is up, line protocol is up 

Internet address is 155.1.1.1/16 

Broadcast address is 255.255.255.255 

Address determined by setup command 

MTU is 1500 bytes 

Helper address is not set 

Directed broadcast forwarding is disabled 

Outgoing access list is not set 

Inbound access list is not set 

Proxy ARP is enabled 

Local Proxy ARP is disabled 

Security level is default 

Split horizon is enabled 

ICMP redirects are always sent 

ICMP unreachables are always sent 

ICMP mask replies are never sent 

IP fast switching is enabled 

IP fast switching on the same interface is disabled 

IP Flow switching is disabled 

IP CEF switching is enabled 

IP Feature Fast switching turbo vector 

IP VPN Flow CEF switching turbo vector 

IP multicast fast switching is enabled 

IP multicast distributed fast switching is disabled 

IP route-cache flags are Fast, CEF 

Router Discovery is disabled 

IP output packet accounting is disabled 

IP access violation accounting is disabled 

TCP/IP header compression is disabled 

RTP/IP header compression is disabled 

Policy routing is enabled, using route map PBR 

Network address translation is disabled 

BGP Policy Mapping is disabled 

IP Multi-Processor Forwarding is enabled 

IP Input features, "PBR", 

are not supported by MPF and are IGNORED 

IP Output features, "NetFlow", 

are not supported by MPF and are IGNORED