Cisco Systems NPE-225 사용자 설명서

7-50

Network Processing Engine and Network Services Engine Installation and Configuration

OL-4448-12

Chapter 7 NPE-G1 and NPE-G2 Installation and Configuration Information

Enabling the Second Processor on the NPE-G1

CPU% per hour (last 72 hours)

* = maximum CPU% # = average CPU%

Using the show mpf interface Command

Using the show mpf interface command without arguments shows the interface information for all
Gigabit Ethernet interfaces and subinterfaces. This command is supported only for physical interfaces.
There is no support for the virtual access interface.

Router# show mpf interface

Name

Index State Counter

Count

Gi0/1 0 up

packets

1004

RX bytes

158632

TX packets 5004

TX bytes

790632

RX punts

32961

TX punts

85972

Gi0/1 1 up

Gi0/1.100 100

packets

1004

RX bytes

158632

TX packets 5004

TX bytes

790632

RX punts

Gi0/1.101 101

Gi0/1.102 102

Gi0/1.105 105

Gi0/1.106 106

Gi0/1.107 107

Gi0/1.200 200

Gi0/1.201 201

RX punts 29

Gi0/1.202 202

Gi0/1.206 206

Gi0/1.2002 602

RX punts

26114

Gi0/1.2004 604

Using the show mpf interface GigabitEthernet 0/1 Command

The following example displays the interface information for GigabitEthernet 1/0, subinterface number
100. However, all Gigabit Ethernet interface and subinterface information is displayed because MPF
does not recognize the subinterface number, unless it is a VLAN number.

Router# show mpf interface GigabitEthernet 0/1.100

Name Index State Counter Count

Gi0/1 0 up RX packets 1004

RX bytes 158632

TX packets 5004

TX bytes 790632

RX punts 32996

TX punts 86062

Gi0/1 1 up

Gi0/1.100 100 up RX packets 1004

RX bytes 158632

TX packets 5004

TX bytes 790632

RX punts 25

Gi0/1.101 101 up

Gi0/1.102 102 up

Gi0/1.105 105 up

Gi0/1.106 106 up

Gi0/1.107 107 up

Gi0/1.200 200 up