Panasonic WV-CU650 사용자 설명서

33

■ Tour Sequence/Group Sequence

Sequence monitoring is the function to switch camera
images automatically, according to the order registered in
the system unit. The following procedure is available when
a selected system unit has the tour or group sequence
monitoring function.

Note: Before performing the procedure, the sequence

setup of system unit is required.

1. Select a system unit and monitor. (Refer to p. 31

System Unit Selection and p. 32 Monitor Selection.)

2. Enter a desired sequence number.

3. To activate a tour sequence, press the TOUR

SEQ/GROUP SEQ button. 
To activate a group sequence, press the TOUR
SEQ/GROUP SEQ button while holding down the SHIFT
button. The sequence will be activated, and “Seq” will
appear on the monitor, in place of the camera number.

• If you have skipped entering the sequence number

in Step 2, Tour or Group Sequence 1 will be activat-
ed.

• If the selected recorder supports sequence paus-

ing, you can pause the sequence by pressing the
SEQ PAUSE/SEQ STOP button. During the
sequence pause, “Seq-P” will appear on the LCD in
place of “Seq”.

3. To quit the sequence monitoring, press the SEQ

PAUSE/SEQ STOP while holding down the SHIFT but-
ton. The monitor display will return to the spot mode.

Note: If the selected system unit does not support

sequence stop, stop the sequence by selecting a
camera or activating the multiscreen display. (Refer
to p. 32 Camera Selection or Multiscreen Display in
this page.)

■ On-screen Display (OSD)

You can toggle the OSD information (display parameters
such as camera title, monitor number, and recorder num-
ber) on the active monitor screen.

The following are the procedures to control system units
(including recorders). 

■ Multiscreen Display

The following procedure is available when a selected sys-
tem unit (for example, a hard disk recorder) has the multi-
screen display function.

1. Select a system unit and monitor. (Refer to p. 31

System Unit Selection and p. 32 Monitor Selection.)

2. Do either of the following.

• Press the MULTI SCREEN button.
• Press the desired numeric buttons (refer to the dia-

gram), then press the MULTI SCREEN button.

Images will be displayed in the specified multiscreen
segment pattern on the monitor. Every pressing the
MULTI SCREEN button can change the multiscreen
segment pattern.

0

4 segments

1

7 segments

2

9 segments

3

10 segments

4

13 segments

5

16 segments

Note: Available multiscreen segment patterns differ

depending on system units. Refer to the operating
instructions of system units.

■ Electronic Zooming

The following procedure is available when a selected sys-
tem unit has the electronic zooming function.

1. Select a system unit, monitor, and camera. (Refer to p.

31 System Unit Selection, p. 32 Monitor Selection, and
p. 32 Camera Selection)

2. Press the EL-ZOOM button. The camera image on the

monitor will be zoomed. Every pressing the EL-ZOOM
button can change the zooming rate.

3. To move the zoomed area, move the 3D joystick to

desired directions. (Refer to the operating instructions
of system unit.)

Note: Available zooming rates differ depending on sys-

tem units. (Refer to the operating instructions of sys-
tem units for details.)

Mon02 Seq      HD316

  F1   F2   F3   F4