Panasonic AW-PH360N 사용자 설명서

- 26 -

$

Connect the pan/tilt head with the AW-PS300A AC adapter designed for use with the
pan/tilt head.

Standard bare end length 11 mm
It is recommended that the tip be soldered.

>

Connect this to the DC 15V OUT
connector on the AC adapter 
(AW-PS300A). (The voltage output from
the AC adapter is set to 15V: this takes
into consideration the voltage drops due
to the possible extension of the DC
cable between the pan/tilt head and AC
adapter.)
Make sure that the positive 

+

and

negative 

-

ends of the wires are

connected to the same signs on the
connector.
Use a cable with a nominal cross
section of 1.25 mm

2

or more that meets

the UL specifications for the connection.
The maximum allowable cable length is
98.4 ft. (30 meters).

Applicable (usable) wire

UL Type SPT-2 

2

!

16 AWG or

UL Type NISPT-2  2

!

16 AWG

?

Connect this only when the power of a
halogen lamp is to be supplied from the
AC adapter (AW-PS300A).
This connector is connected to LAMP

CONTROL on the AC adapter for the
pan/tilt head.
The symbols C and S on the wires must
match the same symbols on the
connector.
Use a cable with a nominal cross
section of 0.3 mm

2

or more that meets

the UL specifications for the connection.
The maximum allowable cable length is
98.4 ft. (30 meters).

@

Connect this only when the OP SW
CONTROL OUT connector on the AC
adapter (AW-PS300A) is to be used.
Connect it to the OPTION SW
CONTROL IN connector on the AC
adapter (AW-PS300A).
Use a cable with a nominal cross
section of 0.3 mm

2

or more that meets

the UL specifications for the connection.
The maximum allowable cable length is
98.4 ft. (30 meters).