Panasonic AW-PH360N 사용자 설명서

- 27 -

$

1

When the camera and pan/tilt head are to be controlled by the AW-RP501 control panel
for transmitting composite signals

• Use the supplied camera cable to connect the unit with the convertible camera.
• Set controller selection switch SW1 to the right side (RP501), and select the

transmission signal selection setting that supports the analog/IEEE1394 card.

• Use a 10BASE-T straight cable (UTP category 5) to connect the unit’s CONTROL IN

IP/RP connector with the controller’s PAN TILT CONTROL OUT connector.

• Use a coaxial cable (BELDEN 8281) to connect the unit’s CAMERA CONTROL IN

connector with the controller’s CAMERA CONTROL OUT connector.

• Use a coaxial cable (BELDEN 8281) to connect the unit’s VIDEO OUT connector with

the controller’s VIDEO IN connector.

• Use a coaxial cable to connect the controller’s VIDEO OUT connector with the color

monitor’s VIDEO input connector.

• Check that the pan/tilt head and camera can be controlled by the controller.

!

!