Netgear WG302v2 사용자 설명서
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
Management and Information
3-3
v1.0, May 2006
Using the Secure Telnet Interface
The WG302v2 includes a secure Telnet command line interface (CLI). You can access the CLI
from a secure Telnet client over the Ethernet port or over the serial console port.
from a secure Telnet client over the Ethernet port or over the serial console port.
Accessing the CLI by Using the Console Port
1. Using a null-modem cable, connect a VT100/ANSI terminal or a workstation to the port
labeled Console.
If you attached a PC, Apple Macintosh, or UNIX workstation, start a secure
terminal-emulation program.
terminal-emulation program.
2. Configure the terminal-emulation program to use the following settings:
•
Baud rate: 9600 bps
•
Data bits: 8
•
Parity: none
•
Stop bit: 1
•
Flow control: none
These settings appear below the connector on the back panel.
3. Press ENTER, and a screen similar to the one in
should appear.
The login name is admin and password is the default password.
Note: You must use a secure Telnet client such as PuTTY. Also, when you configure the
client, use the SSH1, 3DES option. If you use the Telnet client to connect over the
Ethernet port, use the IP address of the WG302v2 as the host name.
Ethernet port, use the IP address of the WG302v2 as the host name.
Figure 3-3