Netgear WN802Tv2 전단

This symbol was placed in accordance with the European Union Directive 2002/96 on the 
Waste Electrical and Electronic Equipment (the WEEE Directive). If disposed of within the 
European Union, this product should be treated and recycled in accordance with the laws of 
your jurisdiction implementing the WEEE Directive.

© 2007 by NETGEAR, Inc. All rights reserved. NETGEAR, the NETGEAR logo and RangeMax are trademarks 
or registered trademarks of NETGEAR, Inc. in the United States and/or other countries. Other brand and product 
names are trademarks or registered trademarks of their respective holders. Information is subject to change with-
out notice.

Using a computer with an 802.11g, 802.11b or 802.11n wireless adapter, verify 
connectivity by using a browser such as Netscape®, Internet Explorer or Mozilla 
Firefox® to connect to the Internet, and check for file and printer access on your network.
Note: If you cannot connect, see the Troubleshooting Tips in this guide or the link to the 
Reference Manual on the Resource CD.

Here are some tips for correcting simple problems you may have.
No lights are lit on the access point. 
The access point has no power.
•

Make sure the Power Supply is connected to the access point and plugged in to a 
working power outlet or power strip.

•

Make sure you are using the Netgear Switching Power Supply supplied with your 
access point.

The Ethernet light is not lit. 
There is a hardware connection problem.
•

Make sure the cable connectors are securely plugged in at the access point and the 
network device (hub, switch, or router).

•

Make sure the connected device is turned on.

The WLAN light is not lit. 
The access point’s antennas are not working.
•

If the Wireless LAN activity light stays off, disconnect the adapter from its power 
source and then plug it in again.

•

Contact NETGEAR if the WLAN light remains off.

I cannot configure the access point from a browser. 
Check these items:
•

The WN802Tv2 is properly installed and it is powered on. Check that the Ethernet 
port LED is green to verify that the Ethernet connection is OK.

•

If your PC uses a Fixed (Static) IP address, ensure that it is using an IP Address in the 
range of the WN802Tv2. The WN802Tv2 default IP Address is 192.168.0.233 and 
the default Subnet Mask is 255.255.255.0. The WN802Tv2 default setting is for a 
static IP address. If the network where you are connecting it is using DHCP, configure 
it accordingly. See the Reference Manual on the Resource CD for the Wireless Access 
Point for more details. 

Note: The factory default reset button and the default settings for your wireless-N 

access point are located on the label at the rear of your WN802Tv2.

computer. 
There is a configuration problem. Check these items:
•

You may not have restarted the computer with the wireless adapter to have TCP/IP 
changes take effect. Restart the computer.

•

The computer with the wireless adapter may not have the correct TCP/IP settings to 
communicate with the network. Restart the computer and check that TCP/IP is set up 
properly for that network. The usual setting for Windows on the Network Properties 
is set to “Obtain an IP address automatically.”

•

The access point’s default values may not work with your network. Check the access 
point default configuration against the configuration of other devices in your network.

•

For full instructions on changing the access point’s default values, consult the 
documentation links on the Resource CD or on the menu of the wireless-N access 
point user interface.

Thank you for selecting NETGEAR products. 
To register your product, go to: http://www.NETGEAR.com/register
Go to http://www.NETGEAR.com/support for support information.