Tandberg Data Tandberg LTO2 사용자 설명서

 

- 14 -

 

 
 
In this chapter, a description is provided of the operation methods that should be known for the 
daily use of the Autoloader as well as information about the LCD indications.   
 
 

 
Follow the procedure described below to remove the magazine from the Autoloader.  
 
1. Check that the power of the Autoloader is ON. 
 

 

The Autoloader has a double locking mechanism comprising a door lock and 
an electronic lock. When the power is in the OFF condition, the electronic lock 
is activated by a solenoid and the door cannot be opened. When it is necessary 
to open the door while the power is in the OFF condition, use the emergency 
release key that has been supplied. See “3.8 Using the Emergency Release 
Key” for information describing the use of the emergency release key.

 

 
2. Use the door lock key supplied with the main unit to release the door lock, then open the front   
  door.  

 

 

The Autoloader is designed so that the electronic lock operation will again be 
activated if the front door is not opened within 10 seconds following the 
release of the door lock with the door lock key. Should the door become locked 
again, follow this same procedure to release the door lock and then open the 
front door within 10 seconds.

 

 
3. Refer to the diagram affixed to the inside of the front door and press down on the lock lever   
    located at the lower left to release the magazine lock (see figure 3-1).   
 
4. Pull out the magazine that has protruded (see figure 3-2). 
 
 
 
 
 
 
 
 
 
 
 

 

         Figure 3-1 Lock Lever               Figure 3-2 Pulling out the Magazine