Intel SRCSATAWB 사용자 설명서

9

Configure the RAID Controller

1. Turn on the system power and listen to be sure that the SATA devices power up 

before or at the same time as the system. 

2. During the boot, a BIOS message displays to state the keys to press to enter the 

Intel

®

 RAID BIOS Console 2, such as

Press <CTRL><G> to run BIOS Console 2.

This message times out after several seconds. If you miss it, you need to restart the 

system.
After you press the keys to enter the Intel

®

 RAID BIOS Console 2 software, the 

firmware takes several seconds to initialize and then display the RAID Controller 

SRCSATAWB number and firmware version. The numbering of the RAID 

controller follows the PCI slot scanning order used by the server board.

3. See the Intel

 RAID Controller SRCSATAWB Quick Start User’s Guide and the 

Software User's Guide for instructions to configure the RAID controller and to 

install the operating system drivers.

Replacing a Controller, Resolving a Config Mismatch

To replace the RAID controller, see your server system documentation for instructions to 

remove and then install an add-in adapter. 

If the newly installed RAID controller was previously configured, a message displays 

during POST, stating that there is a configuration mismatch because the configuration data 

in the NVRAM differs from that in the hard drives. Use these steps to resolve the 

mismatch:

1. Press <Ctrl> + <G> when prompted during boot up to access the BIOS 

Configuration Utility.

2. Select Configure > View/Add Configuration to see the NVRAM and drive 

configurations.

3. Since the drives contain the correct configuration, use configuration from the disks.
4. Press <Esc> and select YES to update the NVRAM.
5. Exit and reboot.