Motorola MVME2300 Series 사용자 설명서
3-20
Computer Group Literature Center Web Site
Falcon ECC Memory Controller Chip Set
3
DRAM Arbitration
The Falcon pair has 3 different entities that can request use of the DRAM
cycle controller:
cycle controller:
❏
The PowerPC 60x bus master
❏
The tester
❏
The refresher/scrubber
The Falcon pair’s arbiters assign priority with the refresher/scrubber
highest, the tester next, and the PowerPC 60x bus lowest. When no
requests are pending, the arbiter defaults to providing a PowerPC 60x bus
grant. This provides fast response for PowerPC 60x bus cycles. Although
the arbiter operates on a priority basis, it also performs a pseudo round-
robin algorithm in order to prevent starving any of the requesting entities.
Note that PowerPC DRAM or ROM/Flash accesses should not be
attempted while the tester is in operation.
highest, the tester next, and the PowerPC 60x bus lowest. When no
requests are pending, the arbiter defaults to providing a PowerPC 60x bus
grant. This provides fast response for PowerPC 60x bus cycles. Although
the arbiter operates on a priority basis, it also performs a pseudo round-
robin algorithm in order to prevent starving any of the requesting entities.
Note that PowerPC DRAM or ROM/Flash accesses should not be
attempted while the tester is in operation.
Chip Defaults
Some jumper option kinds of parameters need to be configured by
software in the Falcon pair. These parameters include DRAM and
ROM/Flash attributes. In order to set up these parameters correctly,
software needs some way of knowing about the devices that are being used
with the Falcon pair. One way of providing this information is by using the
power-up status registers in the Falcon pair. At power-up reset, each
Falcon latches the level on its RD0-RD63 signal pins into its power-up
status registers. Since the RD signal pins are high impedance during reset,
their power-up reset level can be controlled by pullup/pulldown resistors.
(They are pulled up internally.)
software in the Falcon pair. These parameters include DRAM and
ROM/Flash attributes. In order to set up these parameters correctly,
software needs some way of knowing about the devices that are being used
with the Falcon pair. One way of providing this information is by using the
power-up status registers in the Falcon pair. At power-up reset, each
Falcon latches the level on its RD0-RD63 signal pins into its power-up
status registers. Since the RD signal pins are high impedance during reset,
their power-up reset level can be controlled by pullup/pulldown resistors.
(They are pulled up internally.)
3Falcon ECC Memory Controller Chip Set
0Programming Model