Acer 08P4100 사용자 설명서
Installing the Mylex Disk Array Controller as the Primary UnixWare Controller with UnixWare 7.x/2.1.3
6-4
Manual No. 775079
6
U
N
I
X
W
A
R
E
☛
Note
If installing onto a system that is SISL capable and
using a SISL capable DAC it is recommended to
disable the SCSI chip driver on the system by entering
the DCU at the appropriate screen then select
Software Device Drivers and disable the appropriate
driver.
using a SISL capable DAC it is recommended to
disable the SCSI chip driver on the system by entering
the DCU at the appropriate screen then select
Software Device Drivers and disable the appropriate
driver.
3. Boot the system from the UnixWare Diskette.
4. Follow the instructions provided in the UnixWare Installation
Handbook. The Mylex Disk Array Controller driver for UnixWare is
included on the Software Kit UnixWare (dak) driver diskette which
was made from the Software Kit CD-ROM.
included on the Software Kit UnixWare (dak) driver diskette which
was made from the Software Kit CD-ROM.
• During the installation, you will be prompted to either Install Host
Bus Adapter Drivers or Continue Installation.
• Select Install Host Bus Adapter Drivers,
• Insert the Software Kit UnixWare (dak) driver diskette as instructed,
and continue with the instructions provided in the UnixWare
Installation Handbook.
Installation Handbook.
• The controller should be detected automatically during the install
process.
5. After the installation of boot files, the system is automatically shut
down.
Use /dev/rct0 and /dev/cdrom/c0b0txl0 (x is the CD-ROM SCSI ID
number) to access tape and CD-ROM devices after installation.
number) to access tape and CD-ROM devices after installation.