Acer 08P4100 사용자 설명서

Installing the Mylex Disk Array Controller as the Primary UnixWare Controller with UnixWare 2.1.2

6-6

Manual No. 775079

Mylex multifunction controllers use firmware 4.x or above. A special patch 
is required for operation of these controllers with UnixWare 2.1.2 (not 
required for UnixWare 2.1.3 or 7.x on x86). Follow the steps below to 
download the patch files and create diskettes.

☛

If you are installing UnixWare 7.x or UnixWare 2.1.3 
as a primary controller, please refer to “Installing the 
Mylex Disk Array Controller as the Primary 
UnixWare Controller with UnixWare 7.x/2.1.3” on 
page 6-3. 

1. Download the following files from the Technical Support area of the 

Mylex web site:

ptf3256.boot.dd.exe

ptf3256.s.exe

2. Insert a non-bootable DOS-formatted floppy diskette in the diskette 

drive and run:

↵

3. Remove the first diskette, then insert a second non-bootable 

DOS-formatted floppy diskette in the diskette drive and run:

↵

Use the two diskettes you’ve just created when requested in the procedure 
below.

To install the UnixWare driver for the Mylex Disk Array Controller:

1. Follow the instructions in the appropriate Mylex Disk Array Controller 

manuals to set up the hardware, install the controller, connect the disk, 
tape, and/or CD-ROM drives, and run the RAID EzAssist 
Configuration Utility to create Drive Groups and System Drives. 

☛

CD-ROM or tape drives may be connected to any