Cisco Systems ONS 15600 사용자 설명서

Complete the 

 to log into an ONS 15600 on the network.

Click the Alarms tab:

Verify that the alarm filter is not turned on. See the 

 as necessary.

Verify that no unexplained conditions appear on the network. If unexplained conditions appear, 
resolve them before continuing. Refer to the Cisco ONS 15600 SONET Troubleshooting Guide.

Complete the 

 to export alarm and condition 

information.

In node view, double-click the ASAP card where you want to provision PPM settings. 

Click the Provisioning > Pluggable Port Modules tabs. 

In the Pluggable Port Modules pane, click Create. The Create PPM dialog box appears.

In the Create PPM dialog box, complete the following:

PPM—Click the slot number where the SFP is installed from the drop-down list.

PPM Type—Click the number of ports supported by your SFP from the drop-down list. If only one 
port is supported, PPM (1 port) is the only menu option. 

Click OK. The newly created port appears on the Pluggable Port Modules pane. The row on the 
Pluggable Port Modules pane turns light blue and the Actual Equipment Type column lists the equipment 
name.

Verify that the PPM appears in the list on the Pluggable Port Modules pane. If it does not, repeat Steps 

 through 

. 

Repeat the task to provision a second PPM.

Click OK.

Continue with the 

 to provision the 

line rate.

This procedure provisions a multirate pluggable port modules (PPMs) in 
CTC. 

None

, as needed

Required

Onsite or remote

Provisioning or higher