Netgear WGR614v7 사용자 설명서

Maintenance

5-7

It is sometimes desirable to restore the router to original default settings. This can be done by using 
the Erase function, which will restore all factory settings. After an erase, the router's password will 
be password, the LAN IP address will be 192.168.1.1, and the router's DHCP client will be 
enabled.

To erase the configuration, click the Erase button.

To restore the factory default configuration settings without knowing the login password or IP 
address, you must use the Default Reset button on the rear panel of the router. See 

.

The routing software of the wireless router is stored in FLASH memory, and can be upgraded as 
new software is released by NETGEAR. Upgrade files can be downloaded from the NETGEAR 
Web site. If the upgrade file is compressed (.ZIP file), you must first extract the file before sending 
it to the router. The upgrade file can be sent to the router using your browser. 

Note: The Web browser used to upload new firmware into the wireless router must support HTTP 
uploads. NETGEAR recommends using Microsoft Internet Explorer 5.0 and above and Netscape 
Navigator 4.7 and above. 

From the Main Menu of the browser interface, under the Maintenance heading, select the Router 
Upgrade link display the menu shown below. 

Note: Before upgrading the router software, use the router backup utility to save your 
configuration settings. Any router upgrade will revert the router settings back to the 
factory defaults. After completing the upgrade, you can restore your settings from the 
backup.