Netgear WNR1000v3h2 사용자 설명서

29.

29.

Is your router set to a wireless standard that is not supported by your wireless adapter? 

11.

If your wireless network appears, but the signal strength is weak, check these conditions:

Is your router too far from your adapter, or too close? Place the computer that has the 

adapter near the router, but at least 6 feet away, and see whether the signal strength 
improves.

Is your wireless signal obstructed by objects between the router and your adapter? See 

Restoring the Default Configuration and Password

This section explains how to restore the factory default configuration settings that reset the 
router’s user name to admin, the password to password, and the IP address to 192.168.1.1.

You can erase the current configuration and restore factory defaults in two ways:

84.

Use the restore factory settings button on the rear panel of the router. Use this method for 

cases when the administration password or IP address is not known.

To use the restore settings button:

Locate the restore factory settings button on the rear panel of the router.

Use a sharp object such as a pen or a paper clip to press and hold the restore factory 

settings button for about 5 seconds, until the Power light begins to blink.

Release the restore factory settings button, and wait for the router to restart, and for the 

Power light to stop blinking and become solid green.

The factory default settings will be restored so that you can access the router from your 
Web browser using the factory defaults.

If the wireless router fails to restart, or the Power light continues to blink or turns solid amber, 
the unit might be defective. If the error persists, you might have a hardware problem and 
should contact Technical Support at 

.