Netgear WNR1000v3h2 사용자 설명서

Erasing the Configuration

Under some circumstances (for example, if you move the router to a different network or if 
you have forgotten the password) you might want to erase the configuration and restore the 
factory default settings. After an erase, the router’s username is admin, the password is 
password, the LAN IP address is 192.168.1.1 (or www.routerlogin.net), and the router’s 
DHCP server is enabled.

To erase the configuration, click the Erase button in the Settings Backup screen.

To restore the factory default configuration settings when you do not know the login 
password or IP address, you must use the restore factory settings button on the rear panel of 
the router (see 

Updating the Router Firmware

The firmware of the WNR1000v3h2 router is stored in flash memory, and can be updated as 
NETGEAR releases new firmware. You can update your firmware by logging into the router 
and using one of these procedures:

Enable the Check for Updated Firmware Upon Log-in check box. Each time you log 

in to the router, it will automatically detect a new version of the firmware and then install it. 
This check box is enabled in the router’s default state. See 

7.

Use the Check button in the Router Upgrade screen. Instead of having the router 

check for new firmware every time you log in, you can use Router Upgrade, under 
Maintenance in the main menu. See 

.”

Check for and update your firmware manually. You can compare versions, obtain new 

86.

Before updating the router software, NETGEAR recommends that 

you save your configuration settings (see 

83). A firmware update might cause the 

router settings to revert to the factory defaults. If this happens, after 
completing the update, you can restore your settings from the 
backup.

Checking for New Firmware in the Router Upgrade Screen

To check for new firmware and allow the router to automatically install it:

Select Router Upgrade under Maintenance in the main menu. The Router Upgrade 

screen displays.