Netgear WNR2000-100FSS 사용자 설명서

After you turn on power to the router, the following sequence of events should occur:

When power is first applied, verify that the Power LED 

 is on.

Verify that the Power LED turns amber within a few seconds, indicating that the self-test is 

running.

After approximately 30 seconds, verify that:

The Power LED is solid green.

The Internet LED is lit.

A numbered Ethernet port LED is on for any local port that is connected to a 

computer. This indicates that a link has been established to the connected device.

You can use the LEDs on the front panel of the router for troubleshooting.

Make sure that the power cord is securely connected to your router and that the power 
adapter is securely connected to a functioning power outlet. 

Check that you are using the 12V DC, 1.5A power adapter that NETGEAR supplied for 
this product.

If the Power LED blinks slowly and continuously, the router firmware is corrupted. This 
can happen if a firmware upgrade is interrupted, or if the router detects a problem with the 
firmware. If the error persists, you have a hardware problem. For recovery instructions, or 
help with a hardware problem, contact technical support at 

.

When the router is turned on, the Power LED turns amber for about 20 seconds and then 
turns green. If the LED does not turn green, the router has a problem.

If the Power LED is still amber 1 minute after you turn on power to the router:

Turn the power off and back on to see if the router recovers.

Press and hold the Restore Factory Settings button to return the router to its factory 

settings. 

If the error persists, you might have a hardware problem and should contact technical 
support at 

When the router is turned on, the LEDs light for about 10 seconds and then turn off. If all the 
LEDs stay lit, there is a fault within the router.