Netgear WNR2000-100FSS 사용자 설명서

If all LEDs are still lit 1 minute after power-up:

Turn the power off and back on to see if the router recovers.

Press and hold the Restore Factory Settings button to return the router to its factory 
settings. 

140.

If the error persists, you might have a hardware problem and should contact technical 
support at 

www.netgear.com/support

.

If either the LAN port LEDs or the Internet LED does not light when the Ethernet connection is 
made, check the following:

Make sure that the Ethernet cable connections are secure at the router and at the modem 
or computer.

Make sure that power is turned on to the connected modem or computer.

Be sure that you are using the correct cable:

When you connect the router’s Internet port to a cable or DSL broadband modem, use 
the cable that was supplied with the cable or DSL broadband modem. This cable could be 
a standard straight-through Ethernet cable or an Ethernet crossover cable.

If the Wireless LED stays off, check to see if the WiFi On/Off button on the router has been 
pressed. This button turns the wireless radio in the router on and off. The Wireless LED is lit 
when the wireless radio is turned on.

If, after you use the WPS function, the WPS LED blinks green rapidly, check the following:

Make sure that you have used the WPS button on the front of the router and not the 
WPS

 

Wizard on the Add WPS Client screen.

Check that PIN verification has succeeded for the wireless device you are adding to the 
wireless network.

Make sure that you have not pressed the WPS button on the front of the router after 
disabling the WPS feature (you logged in to the router and disabled this previously).

The router is stuck in the AP setup locked state (if you are using the wireless repeater 
function). To resolve this situation, either restart the router, or do the following:

Select Advanced > Advanced Setup > Wireless Settings. 

The Advanced Wireless Settings screen displays.

Select the Enable Router's PIN check box.