Netgear RT314 사용자 설명서
Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers
Using the Manager Interface for Initial Router Configuration
7-9
WAN Setup
Menu 2 enables you to configure the 10 Mbps Ethernet port to a broadband modem device, such as
a cable or DSL modem. This port is labeled INTERNET on the rear panel of the router.
a cable or DSL modem. This port is labeled INTERNET on the rear panel of the router.
shows Menu 2 - WAN Setup.
Figure 7-4.
Menu 2 - WAN Setup
lists and describes the fields for Menu 2 - WAN Setup.
Table 7-3.
WAN Setup Fields
Field
Description
MAC Address
The MAC Address is the 48-bit Ethernet address of the router’s INTERNET port.
Assigned By
Set to Factory default to use the router’s internal globally unique MAC address.
Set to ‘IP address attached on LAN’ to acquire and substitute the MAC address of
one of your PCs on the local network. Some ISPs will only accept traffic from the
MAC address of one PC. This feature allows your router to masquerade as that PC
by using its MAC address.
Set to ‘IP address attached on LAN’ to acquire and substitute the MAC address of
one of your PCs on the local network. Some ISPs will only accept traffic from the
MAC address of one PC. This feature allows your router to masquerade as that PC
by using its MAC address.
IP Address
If you selected IP address attached on LAN in the previous field, you must specify
the IP address of the local PC with the MAC address to be used by the router.
the IP address of the local PC with the MAC address to be used by the router.
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
Press ENTER to Confirm or ESC to cancel: