Netgear WNR1000V2 사용자 설명서

Safeguarding Your Network

2-13

.

If your wireless clients support Wi-Fi Protected Setup (WPS), you can use this feature to configure 
the router’s network name (SSID) and security settings and, at the same time, connect a wireless 
client securely and easily to the router. Look for the 

 symbol on your client device. WPS 

automatically configures the network name (SSID) and wireless security settings for the router (if 
the router is in its default state) and broadcasts these settings to the wireless client. 

When you add wireless clients, whether or not they are WPS enabled, the added devices must 
share the same network name (SSID) and security passphrase. For more information, see 

The WNR1000v2 router provides two methods for connecting to a wireless client that supports 
WPS, described in the following sections: 
•

”

•

There are two methods to enable a wireless client to join a network using a push button on the 
router: using the physical push button or using the software button in the Add WPS Client screen.

1. Press the button on the rear of the WNR1000v2 router for over 5 seconds. For information 

about the WPS light, see the NETGEAR Wireless Router Setup Manual.

The green 

 light begins to blink in a regular pattern. While the light is blinking, you have 2 

minutes to enable WPS on the client that you are trying to connect to the router.

Note: NETGEAR’s Push 'N' Connect feature is based on the Wi-Fi Protected Setup 

certified and WPS-capable products should be compatible with NETGEAR 
products that implement Push 'N' Connect.

Note: If you choose to use WPS, the only security methods supported are WPA-PSK and 

WPA2-PSK. WEP security is not supported by WPS.