Netgear WG602 V2 사용자 설명서

Advanced Configuration

5-3

1.

Verify the following parameters for all access points:

•

Verify that the LAN network configuration of the WG602 v2 Access Points are configured 
to operate in the same LAN network address range as the LAN devices

•

If using DHCP, all WG602 v2 Access Points should be set to “Obtain an IP address 
automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings 
menu.

•

If MAC access control list security is enabled on the APs, verify that the MAC access 
control lists on each AP are complete for the entire network and accurate.

•

All WG602 v2 Access Points use the same SSID, Channel, WEP authentication mode, if 
any, and encryption in use (WPA is not available in bridge modes).

•

All Point-to-Point APs must have AP2’s MAC address in its Remote AP MAC address 
table. You can locate the MAC address in the Information page of each WG602 v2.

Note: The 54 Mbps Wireless Access Point WG602 v2 bridging and repeater modes are 
only compatible with the NETGEAR WG602v2 and the NETGEAR WG302 Wireless 
Access Points. 

E T H E R N E T

Wireless PC Card
in a Notebook Computer

Wireless PC Card
in a Notebook Computer