Netgear WG602 V2 사용자 설명서

5-4

Advanced Configuration

2.

Configure AP1 in Point-to-Point mode with the MAC address of AP2 and deploy it on LAN 
Segment 1. If you check the Enable Wireless Client Association checkbox, wireless clients 
will also be able to use AP1. If the Enable Wireless Client Association checkbox is not 
selected, only computers on Ethernet LAN segment 1 will use AP1 to communicate with AP2.

3.

Configure AP2 in Point-to-Point mode with the MAC address of AP1 and deploy it on LAN 
Segment 2. Use the same security and channel settings as AP1. If you check the Enable 
Wireless Client Association checkbox, wireless clients will also be able to use AP2. If the 
Enable Wireless Client Association checkbox is not selected, only computers on Ethernet 
LAN segment 2 will use AP2 to communicate with AP1.

4.

Verify connectivity across the network. 

If you enabled wireless client association on both APs, a computer on either AP should be able 
to connect to the Internet or share files and printers of any other PCs or servers connected to 
the network.

1.

Verify the following parameters for all access points:

Note: The 54 Mbps Wireless Access Point WG602 v2 bridging and repeater modes are 
only compatible with the NETGEAR WG602v2 and the NETGEAR WG302 Wireless 
Access Points. 

E T H E R N E T

E T H E R N E T

E T H E R N E T

E T H E R N E T

E T H E R N E T

E T H E R N E T

Wireless PC Card
in a Notebook Computer