Netgear WG602V4 사용자 설명서
NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Manual
Installation and Configuration
2-19
v1.0, June 2007
To configure WPA-PSK and WPA2-PSK:
1. From under the Setup menu in the left-hand panel, click Security Settings.The Security
Settings screen will display.
2. From the Security Type pull-down menu, select WPA-PSK/WPA2-PSK. By default, the
Encryption Type will display TKIP and AES.
3. In the Password Phrase field, enter a word or group of 8-63 printable characters.
4. Click Apply to save your settings.
Restricting Wireless Access by MAC Address
T
he Access Control screen lets you block or allow network access privileges of specified stations
through the NETGEAR WG602v4 54 Mbps Wireless Access Point. This provides an additional
layer of security. (This feature not available when in Client Mode.).
layer of security. (This feature not available when in Client Mode.).
Figure 2-15
Note: If you use a wireless PC to configure WPA settings, you will be disconnected
when you click Apply. Reconfigure your wireless adapter to match the new
settings or access the wireless access point from a wired PC to make any
further changes.
settings or access the wireless access point from a wired PC to make any
further changes.
Note: When configuring the WG602v4 from a wireless PC whose MAC address is not in
the access control list, if you select Turn Access Control On, your wireless
connection will be lost when you click Apply. You must then access the wireless
access point from a wired PC or from a wireless PC which is on the access control
list to make any further changes.
connection will be lost when you click Apply. You must then access the wireless
access point from a wired PC or from a wireless PC which is on the access control
list to make any further changes.