Netgear RP114 사용자 설명서
Reference Guide for the Model RP114 Web Safe Router
2-4
Setting Up the Hardware
The Router’s Rear Panel
The rear panel of the Model RP114 router is shown in
.
Figure 2-2.
RP114 Rear Panel
The rear panel contains the following features:
•
12 VDC power adapter outlet
•
Factory Default Reset pushbutton
•
Ground lug
Connecting the Router
Before using your router, you need to do the following:
•
Connect your local Ethernet network to the LAN port(s) of the router (described next).
•
Connect your cable or DSL modem to the WAN port of the router (see
).
•
Connect the power adapter (see
).
Connecting to your Local Ethernet Network
Your local network will attach to the router port or ports marked LAN. The LAN ports are capable
of operation at either 10 Mbps (10BASE-T) or 100 Mbps (100BASE-Tx), depending on the
Ethernet interface of the attached PC, hub, or switch. For any connection which will operate at 100
Mbps, you must use a Category 5 (CAT5) rated cable, such as the white Ethernet cable included
with the router.
of operation at either 10 Mbps (10BASE-T) or 100 Mbps (100BASE-Tx), depending on the
Ethernet interface of the attached PC, hub, or switch. For any connection which will operate at 100
Mbps, you must use a Category 5 (CAT5) rated cable, such as the white Ethernet cable included
with the router.