Fujitsu P2X0-0202-01EN 사용자 설명서

2.3 Setting Items

ETERNUSmgr User Guide -Introduction- P2X0-0202-01EN

2.2.2

For Windows®

The following describes how to edit a setup file for ETERNUSmgr for Windows®.
The procedure shown is for changing the settings that were set during installation.

Procedure

Confirm the contents of the installation directory using Explorer, etc.

Make sure the following files and folder have been installed in the installation directory:
_stxpoll.ini, STXPOLL.exe, STXPOLL_1.INI, stxpolld.exe, stxsmail.exe, and \www (\www is a
folder).

Edit the STXPOLL_1.INI file.

Edit the STXPOLL_1.INI file using a text editor (Notepad, etc.).

2.3

Setting Items

This section explains the setting items (parameters) in the setup files.

2.3.1

Target Device Settings

This section explains the settings that allow ETERNUSmgr to monitor a target device.

■

Target Address

The target address parameter is used to set the IP address or host name assigned to the target device.
The target port number does not need to be changed (the default number is normally used).
Target address cannot be omitted. ETERNUSmgr will not start if this parameter has not been set.
Specify SVP IP address if the ETERNUS6000 is using SVP.

[Default value]

TARGET_PORT = 80
(TARGET_ADDR must be set. There is no default.)

[Parameter]

TARGET_ADDR (up to 64 characters)
TARGET_PORT (0-65535)

[Example]

TARGET_ADDR=127.0.0.1 or TARGET_ADDR=host-name.domain-name.com
TARGET_PORT=80

Caution:

• As the default port number is normally used, the target port parameter is initially com-

mented out.

• If the target address is changed, the target address must also be changed in the top

menu ("menu.htm").