Proxim AP-2000 사용자 설명서

24

Proxim provides two tools to simplify the initialization and configuration of an AP:
•

•

ScanTool is included on the Installation CD; the Setup Wizard launches automatically the first time you access the 
HTTP interface.

These initialization instructions describe how to configure an AP over an Ethernet connection using ScanTool 
and the HTTP interface. If you want to configure the unit over the serial port, see 

 for information on how to access the CLI over a serial connection and 

 for a list of supported commands.

ScanTool is a software utility that is included on the installation CD-ROM. ScanTool allows you to find the IP address of 
an Access Point by referencing the MAC address in a Scan List, or to assign an IP address if one has not been 
assigned.
The tool automatically detects the Access Points installed on your network, regardless of IP address, and lets you 
configure each unit’s IP settings. In addition, you can use ScanTool to download new software to an AP that does not 
have a valid software image installed (see 

To access the HTTP interface and configure the AP, the AP must be assigned an IP address that is valid on its 
Ethernet network. By default, the AP is configured to obtain an IP address automatically from a network Dynamic Host 
Configuration Protocol (DHCP) server during boot-up. If your network contains a DHCP server, you can run ScanTool 
to find out what IP address the AP has been assigned. If your network does not contain a DHCP server, the 
Access Point’s IP address defaults to 10.0.0.1. In this case, you can use ScanTool to assign the AP a static IP address 
that is valid on your network.

 Follow these steps to install ScanTool, initialize the Access Point, and perform initial configuration:
1. Locate the unit’s Ethernet MAC address and write it down for future reference. The MAC address is printed on the 

product label. Each unit has a unique MAC address, which is assigned at the factory.

2. Confirm that the AP is connected to the same LAN subnet as the computer that you will use to configure the AP.
3. Power up, reboot, or reset the AP.

–

Result: The unit requests an IP Address from the network DHCP server.

4. Insert the Installation CD into the CD-ROM drive of the computer that you will use to configure the AP.

–

Result: The installation program will launch automatically.

5. Follow the on-screen instructions to install the Access Point software and documentation.

The ORiNOCO Installation program supports the following operating systems:
•

Windows 98SE

•

Windows 2000

•

Windows NT

•

Windows ME

•

Windows XP

6. After the software has been installed, double-click the ScanTool icon on the Windows desktop to launch the 

program (if the program is not already running). 
–

Result: ScanTool scans the subnet and displays all detected Access Points. The ScanTool’s Scan List screen 
appears, as shown in the following example.