Polycom DOC2238A 사용자 설명서
MGC+ Hardware and Installation Manual
2-17
Connecting and Setting Up the MGC+100
Use the MGC+100 rear panel diagram below for reference.
Figure 2-8: MGC+100 Rear Panel with External Connectors
To Connect the MGC+100 to the network and power source and set up
the system the following procedures are performed:
the system the following procedures are performed:
•
Connecting the MGC+ unit to the power source (AC inlet)
•
Connecting the MGC+ unit to the LAN Network
•
Connecting the MGC+ unit to the Operator Workstation (PC) directly via
RS-232 (optional) using COM2
RS-232 (optional) using COM2
•
Connecting the MGC+ unit to the network(s)
MGC+100 Dongle
MGC+100 is shipped with a serial dongle and is installed on COM1 of the
Control Module rear I/O panel. A special bracket ensures that the dongle
remains in its fixed position. The dongle is required for normal operation of
the MCU. If the dongle is missing, please contact support.
Control Module rear I/O panel. A special bracket ensures that the dongle
remains in its fixed position. The dongle is required for normal operation of
the MCU. If the dongle is missing, please contact support.
AC Inlet
Main Switch
Fan
DEBUG
LINE IN
COM2
COM1
KEYBOARD
MOUSE
VGA
LAN
COM2
COM1
KEYBOARD
MOUSE
VGA
LAN
ALARMS