Rosewill RNWB-11001 사용자 설명서

¾

 

Remote Management IP Address - This is the current address you will use when 

accessing your Router from the Internet. This function is disabled when the IP 

address is set to the default value of 0.0.0.0. To enable this function change 0.0.0.0 to 

a valid IP address. If set to 255.255.255.255, then all the hosts can access the Router 

from internet.   

)

1) 

To access the Router, you should type your Router's WAN IP address into your 

browser's address (in IE) or Location (in Navigator) box, followed by a colon and the 

custom port number. For example, if your Router's WAN address is 202.96.12.8, 

and the port number used is 8080, please enter 

 in your 

browser. Later, you may be asked for the Router's password. After successfully 

entering the username and password, you will be able to access the Router's 

web-based utility. 

2) 

Be sure to change the Router's default password to a very secure password. 

 

Figure 4-43 Access Control 

There are four submenus under the Access Control menu as shown in Figure 4-43: Rule, 

Host, Target and Schedule. Click any of them, and you will be able to configure the 

corresponding function. 

 

Please Note: The internet loading will be slow down when under “Access Control” 

 

Choose menu “Access Control → Rule”, you can view and set Access Control rules in 

-80-