Avaya CMC1 사용자 설명서

Three types of back-up batteries are used. See 

for the battery type and rating.

To install the battery mounting/wiring:

1. Insert two #10-32 x 1/2-inch shoulder screws into the top designated battery holes on the 

wall mounting plate. Lightly screw in but do not tighten.

2. Place the keyhole slots in the battery bracket on these two screws. The battery cord exits 

from the right of the bracket. Make sure the label on the battery is visible. Tighten the 
screws securely.

3. Plug the battery cord into the power supply’s right rear receptacle. The rear receptacle is 

indicated on the right label.

A second power distribution unit can be installed to provide power to additional devices.

CAUTION:

Total power cannot exceed 275 watts. The maximum ISDN terminal mixture is 24, 
7500-series and 24, 8500-series terminals.

The maximum DCP terminal mixture is 24, 7400-series and 24, 8400-series or 
64, 8400-series terminals.

The expanded power distribution unit kit contains:

●

One 1146B2 Power Distribution Unit 

●

One “T” Cable 

●

Two #8-32 x 1/2-in. Shoulder Screws

●

One #8-32 x 1-in. Screw

●

One spacer bracket

Refer to 

on page 100 while installing the power distribution 

unit. 

1148B

2.5 amp-hours

1149B

5 amp-hours

1147B

8 amp-hours