Avaya CMC1 사용자 설명서

If the backup was unsuccessful, do the following:

1. If the processor circuit pack was replaced as part of the upgrade, remove the processor and 

replace it with the original processor circuit pack.

2. Insert the original translation card (or backup translation card) into the TN798. This is a csi 

circuit pack only.

3. Enter reset system 4 to reboot the system and to reinstall the original translations.

4. To correct the translation corruption problem, contact your Avaya representative.

If these procedures do not clear the corruption problem, then the software versions may be 
incompatible. You may need to upgrade to an interim software version before upgrading to 
Avaya Communication Manager.

1. Consult the remediation that came with the Avaya Communication Manager.

2. Contact your Avaya representative for this information.

If your upgrade failed and you need to re-install the ISDN-PRI links, use this procedure. 

1. Type add data-module [PI ext] and press Enter.

2. Type the information in the fields based on the information that you entered earlier.

3. Type change communication-interface links and press Enter.

4. Type the information in the fields based on the information that you entered earlier with one 

exception. Leave the 

Enable

 field setting as it is.

5. Type change communication-interface processor-channels and press Enter.

6. Type the information in the fields based on the information that you entered earlier.

7. Type change communication-interface links and press Enter.

8. Type the information in the 

Enable

 field based on the information that you entered earlier.

9. Type save translation and press Enter.