Avaya X330W2-DS1 사용자 설명서
Configuring the X330WAN
Avaya X330W-2DS1 User’s Guide
21
Configuring the X330WAN
An X330WAN can be configured using the Command Line Interface (CLI) utility,
the built-in Avaya P330 Device Manager (Embedded Web), or Avaya MultiService
Network Manager
the built-in Avaya P330 Device Manager (Embedded Web), or Avaya MultiService
Network Manager
™
.
For instructions on using the CLI, refer to Chapter 7, "X330WAN CLI Commands."
For instructions on using the Device Manager or Avaya MultiService Network
Manager
For instructions on using the Device Manager or Avaya MultiService Network
Manager
™,
refer to the Avaya MultiService Network Manager P330 Device
Manager User’s Guide on the Documentation and Utilities CD.
The CLI is command-line driven and does not have any menus. To activate a
configuration option, type the desired command at the prompt and press Enter.
The rest of this section describes the following:
•
The CLI is command-line driven and does not have any menus. To activate a
configuration option, type the desired command at the prompt and press Enter.
The rest of this section describes the following:
•
How to establish a Serial and Modem connection using the CLI.
•
How to configure an X330WAN Fast Ethernet, T1/E1 interface, or loopback,
using the CLI.
using the CLI.
•
How to check and save your configuration using the CLI.
•
How to establish a Telnet session using the CLI.
Establishing a Serial Connection
Perform the following steps to connect a terminal to the Console port of the
X330WAN module for configuration of WAN parameters using the CLI:
1
X330WAN module for configuration of WAN parameters using the CLI:
1
Use the supplied serial cable to attach the RJ-45 console connector to the
Console port on the X330WAN module. Connect the DB-9 connector to the
serial (COM) port on your PC/terminal.
Console port on the X330WAN module. Connect the DB-9 connector to the
serial (COM) port on your PC/terminal.
2
Use the following serial port settings on the terminal:
— Baud Rate - 9600 bps
— Character Size - 8
— Parity - None
— Stop Bit - 1
— Flow Control - None
— Terminal Emulation - VT-100
— Baud Rate - 9600 bps
— Character Size - 8
— Parity - None
— Stop Bit - 1
— Flow Control - None
— Terminal Emulation - VT-100
Note:
The terminal connected to the Console port must be configured with these
settings.
3
Press Enter.
4
When prompted for a Login Name, enter the default name root.
5
When promoted for a password, enter the password root.