Avaya X330W2-DS1 Manual Do Utilizador

Configuring the X330WAN

Avaya X330W-2DS1 User’s Guide

21

Configuring the X330WAN

An X330WAN can be configured using the Command Line Interface (CLI) utility, 
the built-in Avaya P330 Device Manager (Embedded Web), or Avaya MultiService 
Network Manager

™

.

For instructions on using the CLI, refer to Chapter 7, "X330WAN CLI Commands." 
For instructions on using the Device Manager or Avaya MultiService Network 
Manager

™,

 refer to the Avaya MultiService Network Manager P330 Device 

Manager User’s Guide on the Documentation and Utilities CD.
The CLI is command-line driven and does not have any menus. To activate a 
configuration option, type the desired command at the prompt and press Enter.
The rest of this section describes the following:
•

How to establish a Serial and Modem connection using the CLI.

•

How to configure an X330WAN Fast Ethernet, T1/E1 interface, or loopback, 
using the CLI. 

•

How to check and save your configuration using the CLI.

•

How to establish a Telnet session using the CLI. 

Perform the following steps to connect a terminal to the Console port of the 
X330WAN module for configuration of WAN parameters using the CLI:
1

Use the supplied serial cable to attach the RJ-45 console connector to the 
Console port on the X330WAN module. Connect the DB-9 connector to the 
serial (COM) port on your PC/terminal.

2

Use the following serial port settings on the terminal:
— Baud Rate - 9600 bps
— Character Size - 8
— Parity  -  None
— Stop  Bit  -  1
— Flow  Control  -  None
— Terminal Emulation - VT-100

The terminal connected to the Console port must be configured with these 

settings.

3

Press Enter.

4

When prompted for a Login Name, enter the default name root.

5

When promoted for a password, enter the password root.