Cabletron Systems NBR-420 사용자 설명서

To install an LDRAM or SDRAM SIMM, see Figure 3-4 and the steps 
below.

Install an LDRAM or SDRAM SIMM as follows:

1. Insert the SIMM between the connector teeth in the SIMM slot.

2. Pivot the SIMM back until it locks into the clips in the SIMM slot, and 

the SIMM holes fit over the SIMM slot posts.

This section contains procedures on how to add/replace an Ethernet Port 
Interface Module (EPIM) to upgrade or change the capabilities of your 
hub. See Figure 3-5. After installing your new EPIM, refer to appropriate 
EPIM sections in this chapter for connecting media types and to verify 
proper operation.

The components and boards associated with the NBR are 
sensitive to static discharges. Be sure to use an antistatic wrist 
strap and observe all static precautions during this procedure. 
Failure to do so could result in damage to the NBR.