ZyXEL Communications ZyXEL G-560 사용자 설명서

ZyXEL G-560 User’s Guide

82 

Chapter 6 Wireless Screens

Hold in the Reset button for one or two seconds. 

Note: If you hold in the Reset button too long, the device will reset to the factory 

defaults!

Click WIRELESS > SETTINGS > OTIST to configure and enable OTIST. The screen 
appears as shown.

Figure 47   OTIST

The following table describes the labels in this screen.

Table 20   OTIST

One-Touch Intelligent Security Technology

Setup Key

Enter the setup key of up to eight printable characters. The default OTIST setup 

key is "01234567".

Note: If you change the OTIST setup key here, you must also make 

the same change on the wireless client(s).

Yes!

To have OTIST automatically generate a WPA-PSK key, select this check box. If 

you manually configured a WEP key or a WPA-PSK key and you also select this 

check box, then the key you manually configured is used.

Start

Click Start to encrypt the wireless security data using the setup key and have the 

G-560 set the wireless client to use the same wireless settings as the G-560. You 

must also activate and start OTIST on the wireless client at the same time. 
The process takes three minutes to complete.

Start the ZyXEL utility and click the Adapter tab. Select the OTIST check box, enter the 
same Setup Key as your AP’s and click Save.