Technicolor - Thomson 210i 사용자 설명서

The SpeedTouch 210i has a power jack, an uplink port, four RJ-45 ports, an ISDN port 
on the rear panel, and a factory reset button. Please note that only the THOMSON  
supplied power adapter should be connected to the power jack. 
 

♦ 

POWER — This socket is a  16-18 volt, 1000 mA power input jack. If the 
power adapter included with the router has been lost or misplaced, please 
ensure that the replacement adapter meets both the voltage and amperage 
requirements. 

♦ 

ETHERNET – The Ethernet ports function as a normal, dual speed NWay 
Ethernet switch. 

♦ 

Uplink – This port is used to connect the router to another 
switch or hub using a straight-through twisted-pair cable. When 
the Uplink port is used, Port 1x is unavailable. 

♦ 

Ports 1x to 4x – These four ports can be used to connect end-
stations to the router using straight-through cables. 

♦ 

ISDN – This socket is used to connect the ISDN line to an NT-

 

1. 

♦ 

Factory Reset:                                                                                          
Switch on your SpeedTouch 210i.                           
The Status LED flashes.                                                                             
To reset the SpeedTouch 210i to the factory settings: Press and hold the 
button for 5 seconds when the unit is switched on. The Status LED will flash 
more quickly – at this moment, release the button and the router is reset to its 
factory settings.    

       

1. Connect the power adapter to the electrical outlet in the wall and to the power jack on 
the rear panel of the router. 
 
2. The Status LED should be blinking once every 2 seconds.