Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서
OmniChannel
Page 15-14
Deleting Ports from an OmniChannel
You can delete ports from an OmniChannel using the
delprtchnl
command. Follow these
steps:
1. Enter
delprtchnl
.
2. The following prompt displays:
Channel Number :
Enter the channel number on which you want to delete ports. You can check the current
port assignments for a given OmniChannel by using the
port assignments for a given OmniChannel by using the
chnlinfo
command, which is
described in Viewing OmniChannel Parameters on page 15-14.
3. The following prompt displays:
To select a port, the convention - Slot/Physical Port or Slot/Phy.
Port Range. For eg. 2/1 is used to select Physical Port 1 on Slot
2 and 2/2-4 selects physical ports 2,3 and 4 on Slot 2
Slot/Port(s):
Enter the port(s) that you want to delete from this OmniChannel.
Important Note
If you delete the primary port a secondary port will
become the new primary port. The secondary port that
will take over this role is the first secondary port speci-
fied through the
become the new primary port. The secondary port that
will take over this role is the first secondary port speci-
fied through the
crechnl
command.
Deleting a Range of Ports
. To delete a range of ports, enter the slot number, a slash (/), the
port number for the first port, a dash (-), and the port number for the last port. For exam-
ple, to delete ports 3, 4, and 5 on the Fast Ethernet module in slot 2, you would enter:
ple, to delete ports 3, 4, and 5 on the Fast Ethernet module in slot 2, you would enter:
2/3-5
Deleting Multiple Ports
. To delete multiple ports (on the same module) that are not physi-
cally contiguous, enter the slot number, a slash (/), the port number for the first port, a
comma (,), and the slot and port for the next port. For example, to delete ports 3 and 5
on the Fast Ethernet module in slot 2, you would enter:
comma (,), and the slot and port for the next port. For example, to delete ports 3 and 5
on the Fast Ethernet module in slot 2, you would enter:
2/3, 2/5
Viewing OmniChannel Parameters
You can view the current configuration parameters and port assignments for an OmniChan-
nel by using the
nel by using the
chnlinfo
command. Follow these steps:
1. Enter
chnlinfo
.
2. The following prompt displays:
Enter channel number for which information is required:
Enter the channel number for which you want to view information. If you want to view
information on all OmniChannels in the switch, simply press
information on all OmniChannels in the switch, simply press
<Enter>
.