Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 19-70

You can add ports to a port map set once it has been created using the 

 command. 

Follow these steps:

1. Enter the 

 command at a system prompt, as shown:

where 

 is the map set number shown when the map set was created. (To view a 

list of all existing map sets, see Viewing a Port Mapping Set on page 19-72.) For example, 
to modify map set 5, you would enter the following:

2. The following screen displays:

Note that the current ports in the port mapping set are displayed. Use this information to 
make decisions on the ports you want to add or remove from the set.

Enter the line number for the operation you want to perform (a 

 for the ingress list or a 

 

for the egress list), an equal sign (

), and the ports to be added. For example, add port 

3/2 to the ingress list and the egress list, enter the following (in two separate operations):

You can add more than one port to a list by using a comma (

) between slot/port designa-

tions, or a dash (

) between port numbers. For example, if you wanted to make ports 4/1, 

4/6, 4/7, 4/8, and 4/9 egress ports for this map set, you would enter the following:

3. To view the changes, enter a 

 (

), and equal sign (

), and a 

, 

as shown:

This will refresh the Port Mapping Configuration screen and display any changes you 
have made.

4. Quit the session by entering a 

 at the prompt.