Alcatel Carrier Internetworking Solutions Switch/Router 사용자 설명서

Page 19-71

You can remove ports to a port map set once it has been created using the 

 

command. Follow these steps:

1. Enter the 

 command at a system prompt, as shown:

where 

 is the map set number shown when the map set was created. (To view a 

list of all existing map sets, see Viewing a Port Mapping Set on page 19-72.) For example, 
to modify map set 5, you would enter the following:

2. The Port Mapping Configuration screen displays (as shown above in Adding Ports to a 

Enter the line number for the operation you want to perform (a 

for the ingress list or a 

for the egress list), an equal sign (

), and the ports to be added. For example, remove 

port 3/2 to the ingress list and the egress list, enter the following (in two separate opera-
tions):

You can remove more than one port to a list by using a comma (

) between slot/port 

designations, or a dash (

) between port numbers. For example, if you wanted to remove 

ports 4/1, 4/6, 4/7, 4/8, and 4/9 from the egress list of this map set, you would enter the 
following:

3. To view the changes, enter a 

 (view port may configuration), an equal sign (

), and a 

, 

as shown:

This will refresh the Port Mapping Configuration screen and display any changes you 
have made.

4. Quit the session by entering a 

 at the prompt.